Dual Row Timing Chain Conversion Kit
This unique kit was designed by LC Engineering to replace the factory single row timing chain on the 22R & 22RE (85-95) engines with a double row timing chain with metal backed guides. The factory, single chain with it's plastic guides has proven to be a problem even in stock engines. Now you can make your 85-95 engine just as strong as the early 22r and 20r engines with this complete kit. A must for any high-performance engine.
NOTE: Will not work on 81-84 22r engines.
Kit Includes:
- Custom Timing Cover
- New Timing Chain Kit w/Metal Back Guides
- Blueprinted Pro Oil Pump
- New Water Pump
- Oil Pump Drive Spline
- Bolt Kit
- Gaskets & Front Seal
Contact our Tech Support Line for further information at 928-575-2174.
Note: Images are for illustration purposes only. Images may not represent the product listed. Please contact customer service with any questions or concerns: 1-928-505-2501.
|
To open a printable PDF version of this instruction
CLICK HERE
Kit Includes:
- (1) 1015027 Modified Timing Cove
- (1) 1015018 HD Double Row Timing Chain Kit
- (1) 1016069 Pro Oil Pump 81-84
- (1) 1016132 Water Pump 81-84
- (1) 1016066 Oil Pump Drive Spline 81-82
- (1) 1015039 TC Conversion Hardware Kit
Installation Instructions:
Using a Hanes, Chilton, or Toyota service manual, follow procedures for
installing the Timing Chain Conversion Kit. Install this kit the same way you would an OEM single chain. Oil baffle inside valve cover must be modified for clearance of the double cam gear. Do not remove the whole baffle, only the front baffle extension
above the cam gear needs to be removed. Using a 3/8 drill bit, locate the spot welds and drill just enough to release the welds. Remove the baffle extension and debur the oil baffle. Clean valve cover to remove all metal shavings before installation.
When installing the metal guide rails, the curved rail should be placed in the
outward position. This will provide the proper amount of chain tension. The
curved guide can be adjusted to accommodate head and block decking.
Due to the tightness of the new chain, it may be necessary to gently pry up
on the cam gear while sliding it onto the camshaft. Use a screwdriver or similar tool through the center hole on the gear, and inserted into the hole in the cam, gently lift the gear up while sliding the gear back on the cam. Rocking the crankshaft back and forth slightly as needed to line lip the dowel pin. DO NOT FORCE IT ON! The gear should only require slight pressure to
slide onto shaft.
NOTE: Seal the head of the top bolt, and the threads of the upper oil pump bolt
using RTV or Ultra Grey. (Refer to black circles on the illustration below). Timing Cover gaskets are under the false bottom of the Timing Chain kit box.
Replacement Double Chains and Double Chain Kits are all available from LC Engineering.
Timing Chain Conversion Kit Part # 1015012 22R/22RE 1985-1995
This kit uses a Water Pump, Oil Pump and Oil Pump Drive Spline from an early 22R 1981-1984.