Adapter Kit

(Aisin 22R Carb to K&N Filter)

LC Engineering manufactures custom adapters to match your Aisin 22R carburetor to a K&N or similar flanged air filter.

NOTE: Fits any filter with a 5-1/8" mount pattern.

Contact our Tech Support Line for further information at 928-575-2174.

Note: Images are for illustration purposes only. Images may not represent the product listed. Please contact customer service with any questions or concerns: 1-928-505-2501.

1981-1995 22R 2.4L Engines

To open a printable PDF version of this instruction CLICK HERE

This billet air filter adapter will provide the ability to run the K&N (or similar) 2” x 11” free flow cleanable air filter on the stock 2-barrel Aisin Carburetor found on 1981-1995 22R engines.

Kit Includes:

• (1) Billet Adapter


• (1) 6mm x 130mm Filter Stud


• (2) 6mm Nylock Nut


• (1) 6mm Flat Washer

Instructions:

Start by making sure you will have hood clearance before proceeding. Remove the stock air filter and center filter stud from the carburetor. Using a 6mm Nylock nut, install the new filter stud and tighten the Nylock nut against carb body to hold the stud in place. For a dust proof seal, apply a small amount of silicone between the filter adapter and the carb. Install air filter, flat washer and nut. Tighten enough to snug air filter without over tightening.