Billet Wire Loom

(LC 8.5mm Pro Wire Separators)

Not only does this setup look great, but the LC Engineering billet plug wire loom allows you to route your wires away from exhaust heat without worrying about them coming loose. The LC Engineering Billet Plug Wire Loom will keep your plug wires out of harm's way of your header or exhaust manifold while adding a custom look to your engine. You can route your spark plug wires either above or below the loom itself depending on your preference.

NOTE: Not for 22RTE engines. This wire loom will fit LC 8.5mm Pro Spark Plug Wires. Our Pro Wires are made to length for routing with this loom. Most factory wires are going to come up too short to use with this product. If you have "Livewire" Spark Plug Wires, see Part #: 1085007. This product will NOT fit a 22R (carb) application with a factory carb as well as a factory air filter.

Contact our Tech Support Line for further information at 928-575-2174.