Fuel Pressure Bolt Kit
Ever wonder if the fuel regulator is doing its job? Not sure if you're getting the right fuel pressure at the fuel rail? This new fuel bolt kit is the solution to the problem. This kit will replace the banjo bolt on the cold start injector with a new stainless steel bolt that accepts a 1/8 NPT fitting.
NOTE: This kit includes the copper crush washers and Stainless Steel bolt. For the complete kit that includes the 1.5" pressure gauge, see Part #: 2019128.
Contact our Tech Support Line for further information at 928-575-2174.
|
Note: Images are for illustration purposes only. Images may not represent the product listed. Please contact customer service with any questions or concerns: 1-928-505-2501.
|
To open a printable PDF version of this instruction
CLICK HERE
Kit Contents:
- (1) - LC Fuel Pressure Bolt
- (2) - Copper Washers
When installing please make sure to remove OEM crush washer before installing the newly supplied crush washers. The bolt will need to be secured by a wrench when installing any components, Otherwise damage may occur on the fuel rail bolt if it is not properly supported when additional parts are installed. Fuel Pressure bolt should be torqued to no more than 22ft lbs. Check and inspect for any leaks.
Very handy creation 
