Gauge Pillar

(Triple)

Most older Toyota trucks had some pretty basic gauges (speedo, tach and fuel gauge). This doesn't work too well if you want to keep a close eye on the "heartbeat" of your engine. Most drivers want to see water temps, oil pressure, charging voltage, air/fuel mixtures etc... You do not want to see an "idiot light" come on after it is too late to do anything about it! Well, now you can have the extra gauges you want without having to hack up your dash or console. This gauge pillar will allow you to mount two additional gauges on your "A" pillar right next to your windshield. Not only does this make for a very clean look it also puts the gauges right at your eye level for fast easy visibility.

Features:

• Holds three 2-1/16" gauges
• Black textured finish
• Replaces stock pillar (trucks) or surface mounts to stock pillar (4Runners or trucks)
• Includes mounting screws and screw covers

Alternate Pillars:

• 84-88 Double Gauge Pillar (flat top & squared off sides), see Part #: 1099110
• 84-88 Triple Gauge Pillar (flat top squared off sides), see Part #: 1099112
• 89-95 Triple Gauge Pillar (rounded or curved top), see Part #: 1099114

NOTE: This pillar fits best when it is installed on top of the OEM plastic trim pillar. It is NOT a good fit for pickups with full cloth interiors (i.e., no stock plastic trim pillar, only a cloth insert). It will physically fit the pillar, but there will be a gap between the new pillar and the cloth backing.

Contact our Tech Support Line for further information at 928-575-2174.