LC Engineering Header Connector Pipe

(w/ Stubs & Clamps)

This is an LC Engineering direct-fit connector pipe for 81-95 4 wheel drive Toyota trucks. It is a 3-piece design that allows for adjustment to mating up with your existing exhaust as best as possible. This is to be used with the LC Engineering header-only and comes in the direct fit kits. It will not fit any other header on the market today.

NOTE: This set up uses OE 2 bolt flanges on both ends same as our header collector and the stock catalytic converter. The overall length of the main pipe is 25.5" The two stub connectors will only add 1.5" to each end for an overall length of 28.5". You can cut and make it shorter. Not guaranteed to meet up with all catalytic converters on 4 wheel drive trucks. Exhaust gaskets sold separately; (2) required, see Part #: 1044027.

Contact our Tech Support Line for further information at 928-575-2174.

Note: Images are for illustration purposes only. Images may not represent the product listed. Please contact customer service with any questions or concerns: 1-928-505-2501.

Average Customer Review: Average Customer Review: 5 of 5

5 of 5 Total Reviews: 2 Write a review.

0 of 0 people found the following review helpful:

Pretty	January 25, 2018
Reviewer: Ernie Baker from Holly Ridge , NC United States

Good looking tube. Just what I needed to finish the exhaust.

Was this review helpful to you?

0 of 0 people found the following review helpful:

great cuatomer service!	January 25, 2017
Reviewer: john jackson from NJ

When ordering headers for my 22r 4x4 84 pickup, I ordered custom fit since there was already custom exhaust mot realizing that the 02 bung is only in the direct fit kit. Called up, explained my problem and the guys took care of me as well as schooled me in some info. Totally satisfied.

Was this review helpful to you?