Weld-On Oxygen Sensor Flange

(2-Bolt Flange Style)

This flange is made from 3/8" mild steel, then tapped for M8 x 1.25 studs weld on. For the 2 bolt style O2 sensor. NOT for thread-in O2 sensors.

Contact our Tech Support Line for further information at 928-575-2174.

Note: Images are for illustration purposes only. Images may not represent the product listed. Please contact customer service with any questions or concerns: 1-928-505-2501.

Average Customer Review: Average Customer Review: 5 of 5

5 of 5 Total Reviews: 2 Write a review.

0 of 0 people found the following review helpful:

Flange	December 24, 2019
Reviewer: misael tejeda from Modesto, CA United States

Just what I needed for my 5vz swap.

Was this review helpful to you?

0 of 0 people found the following review helpful:

O2 sensor flange	March 28, 2014
Reviewer: George Fox from Flagstaff, AZ United States

High quality machining, I would not have been able to fabricate this for 20$ worth of my time. Also customer service gets 5 stars, when I wrote about a delay with my order it was promptly addressed and shipped. I will gladly do business with LC Engineering again and I highly reccomend them to my friends.

Was this review helpful to you?