Billet Wire Loom

(11mm Livewire Separators)

Not only does this setup look great, but the LC Engineering billet plug wire loom allows you to route your wires away from exhaust heat without worrying about them coming loose. The LC Engineering Billet Plug Wire Loom will keep your plug wires out of harm's way of your header or exhaust manifold while adding a custom look to your engine. You can route your spark plug wires either above or below the loom itself depending on your preference.

NOTE: Not for use with 22RTE. This wire loom will fit "Livewire" 11mm Spark Plug Wires. Our Live Wires are made to length for routing with this loom. Most factory wires are going to come up too short to be used with this product. If you have LC Pro Spark Plug Wires or other aftermarket 8.5mm plug wires, see Part #: 1085006. This product will NOT fit a 22R (carb) application with a factory carb as well as a factory air filter

Contact our Tech Support Line for further information at 928-575-2174.