Taper Reamer

This is the perfect taper reamer for reaming out Toyota and Suzuki pitman arms for the larger, more commonly used FJ80 tie rod ends, like the ones offered in our popular high steer kits. Our taper reamer is 1:10 (1" of taper for every 10" of length) and is also expressed as 1.200" TPF (1.200" of taper for every foot of length). The reamer is made from M2 high speed steel with a 1/2" shank diameter for drill press or mill and a 3/8" square end for use with a tap wrench. Anyone can use this tool. You simply ream out the hole in the pitman arm until you can slide the shank of the TRE in, tighten the castle nut, and install the cotter pin. It takes just a few minutes and can be done with hand tools.

This product should not be used in a manner that violates Federal EPA Laws.

Contact our Tech Support Line for further information at 928-575-2174.

Check out LCEngineering.com for New Products, Tech Articles, Specials & Monthly Newsletters!

Note: Images are for illustration purposes only. Images may not represent the product listed. Please contact customer service with any questions or concerns: 1-928-505-2501.

Average Customer Review: Average Customer Review: 5 of 5

5 of 5 Total Reviews: 1 Write a review.

0 of 0 people found the following review helpful:

Nicely packed	September 11, 2018
Reviewer: Will Sanburg from Charlotte, NC United States

I haven’t used it yet and I’m not even sure I’ll need to. I converted a 1980 2wd pickup to 4wd and was told I needed to ream the stock pitman arm to accommodate the high steer kit. I checked the fit of the tie rod end and it fit beautifully without me reaming the pitman arm.

Was this review helpful to you?