2.28 x 4.7 Dual Transfer Case
(21-Spline / Top Shift / Single Stick)
Dual transfer cases is feature a 4.70 low range gear set in the rear and a stock 2.28 gear set in the front. Each case is fully rebuilt and inspected. Triple drilled flanges are installed on both front and rear output. Available with 21 spline input gear on the front reduction section. Rear reduction section is equipped with 23 spline input gear and coupler. Floorboard and drive shaft modifications are required for dual transfer case installation.
This product should not be used in a manner that violates Federal EPA Laws.
Contact our Tech Support Line for further information at 928-575-2174.
Check out LCEngineering.com for New Products, Tech Articles, Specials & Monthly Newsletters!
Note: Images are for illustration purposes only. Images may not represent the product listed. Please contact customer service with any questions or concerns: 1-928-505-2501.
|