Are you wanting to bolt up a Turbo 350 or 400, 700R, Powerglide etc. to your 20/22 application? This CNC made flexplate was designed to be used with our custom bell housing adapter. It will bolt on the 22R/RE crankshaft then will have to mate to a custom torque converter. This flexplate is drilled for the 22R/RE crankshaft bolt pattern, and must be drilled for your custom torque converter pattern. It is recommended that this be done by a machine shop. Use with transmission adapter plate kit, see Part #: 1033035.
NOTE: The offset of this flexplate is not the same as the factory offset, converter needs to be built to match this flexplate.
Contact our Tech Support Line for further information at 928-575-2174.
To open a printable PDF version of this instruction CLICK HERE
Installation: When running an automatic transmission with LC Engineering’s adapter plate you will need to have a custom torque converter made to bolt to the flexplate. Please make sure that the new torque converter is supported properly into the rear of the crank to properly support the weight.