Weber Fuel Pressure Regulator
(1.5-12lbs)
The regulator's job is to keep the pressure in the fuel system at a constant psi. Your Toyota fuel pressure regulator controls the amount and speed at which fuel is used by your vehicle. A faulty fuel pressure regulator can cause poor fuel mileage, rough running engine or starting problems. This is a simple way to keep your fuel system running right. Weber carbs work best in the 2.5-3psi range.
NOTE: The factory fuel line from the mechanical pump is roughly 1/16" smaller than Weber Regulator/Carb fuel line. Slight pressure is all that is needed to fit the smaller line. If you're running the Weber electric fuel pump, see Part #: 1035046. If your application is a boosted blow thru carburetor setup, see Part #: 1035059.
Contact our Tech Support Line for further information at 928-575-2174.
Note: Images are for illustration purposes only. Images may not represent the product listed. Please contact customer service with any questions or concerns: 1-928-505-2501.
|
To open a printable PDF version of this instruction
CLICK HERE
Specification Notes:
- This high quality adjustable fuel pressure regulator is adjustable from 1.5 - 20 psi.
- This regulator should be mounted on the firewall or the inner fender.
- Fuel hose size is 8mm or 5/16".
- In and out are marked on the housing.
- If you are using a liquid-filled gauge, gauge reading must be done when cold.
Installation:
1. Remove cap using a 12mm wrench
2. Loosen the locking nut at the bottom of the adjuster screw.
3. Using a flat screwdriver and a fuel pressure gauge, adjust the fuel pressure to the desire pressure. Turning screw clockwise will increase pressure, counter clockwise will decrease pressure. Adjust in half turn increments. Weber Carburetor recommended fuel pressure is between 2.5 psi. and 3 psi.
4. Lightly tighten the locking nut making sure the adjustment screw does not move.
5. Tighten the cap while holding the locking nut (the one on the bottom) with another 12mm wrench, so adjustment screw won't move.