 |
1.5" Wheel Spacers
These bolt-on wheel spacers are designed to give you a little more width without changing out your axle for a wider one. Great for use on solid axles conversions to make the front axle similar in width as the wider rear axle found on (86+) Toyota trucks. Bolt pattern is 6 studs on a 5.5" round circle. Only high-quality nuts and studs that are hardness graded and stamped are used. The manufacturer recommends cutting wheel studs for proper fitment.
Features:
- safety graded studs and matching nuts for proper fit
- Made from Billet 6061-T6 aluminum
- Uses Grade 8 Studs and Grade 10.9 nuts
- Five sizes available
- Shipped as a set of (2) spacers with nuts
- Every spacer features a precision machined surface
NOTE: Please be sure to check the image above to verify fitment.
Contact our Tech Support Line for further information at 928-575-2174.
Check out LCEngineering.com for New Products, Tech Articles, Specials & Monthly Newsletters!
|
Note: Images are for illustration purposes only. Images may not represent the product listed. Please contact customer service with any questions or concerns: 1-928-505-2501.
|
Universal (6 on 5.5")
Part# 2060102, 2060104, 2060106, 2060108 – Wheel Spacers (Pair) – 6 Lug x 1.25″Wide (6 on 5.5″)
To open a printable PDF version of this instruction
CLICK HERE
Tools Needed:
- Torque Wrench
- Clean Cloth
- Brake Cleaner
- Thin Wall 19mm/21mm Flip Socket (Trail-Gear P/N 170003-KIT)
- Floor Jack & Jack Stands
Installation Notes:
1. Read all instructions completely and carefully before you begin.
2. Check to make sure the kit is complete and that no parts are missing. If anything is missing, please contact Trail-Gear at (559) 252-4950.
3. Park vehicle on a clean, dry, at, level surface and block the tires so the
vehicle can not roll in either direction.
4. This kit is for off-road use only. It is recommended that the installation steps below be performed by a competent mechanic. Buyers and users of this product hereby expressly assume all risks associated with the installation and use of this kit.
5. DO NOT use more than one wheel spacer per wheel. DO NOT use an impact gun to tighten lug nuts.
Installation Instructions:
- Set the parking brake. Raise the vehicle with a jack and support the vehicle with jack stands.
- Remove the wheel. Clean the lug nuts and wheel mounting surface with brake cleaner and a clean cloth. Save the wheel and lug nuts for re-installation.
- Clean the lug nuts and wheel mounting surface on the hub thoroughly with brake cleaner and a clean cloth.
- Install the spacer onto the hub using the open-end lug nuts provided with wheel spacer. Tighten the lug nuts using a Thin Wall 19mm/21mm socket. Tighten the lug nuts in a star pattern as shown below until all lug nuts are tight
- Using a torque wrench, torque the lug nuts to 100 ft-lbs in the appropriate star pattern as shown above.
- Install the wheel onto the wheel spacer using the lug nuts removed in Step 2. Tighten the lugs nuts in the appropriate star pattern as shown in Step 4. Torque the lug nuts to the torque specified in your owner’s manual. Typically, this will be between 85-110 ft-lbs depending on the make and model of your vehicle.
- After driving the vehicle for 10 miles, remove each wheel and check the torque of the lug nuts on the wheel spacer. Re-tighten as necessary.
- Repeat Step 7 after 50 miles and 100 miles. After that, check the wheel spacer lug nut torque at regular intervals.
|
|
|
Wheel spacers 
